3DLAC was born after looking for a solution inside the CLONE WARS REPRAP SPAIN community. At that moment, the Kapton tape was the only product to fix the first layer to the 3D printers’ surface but its application was complex and required in some cases, especially for larger surfaces, an extreme amount of patience to apply!
So 3DLAC was created and its function is to hold the first plastic coat to the 3D printer platform in order to hold the start of the printing steady, avoiding undesirable mistakes.
3DLAC is the perfect substitute for Kapton tape and other types of fixers due to cost-saving and its easy application.
A light 3DLAC mist over the surface is enough to hold completely the first layer of plastic to the base.
Thanks to the properties of 3DLAC, while the base is hot the extruded plastic is firmly stuck.
Once the printed piece gets cold, it can be taken off smoothly and without any damage to your 3D printed project.