At a low temperature the colour is Green and as the temperature increases the filament turns Yellow and when cools goes back to Green, just holding it in your warm hand can change the colour tone of this 3D Printing Filament.

The filament is delivered to you FREE OF CHARGE  in a sealed, clear plastic bag, complete with a sachet of silica gel.

The Traffic Cone that you see was created using a MakerBot Replicator 2 X 3D Printer, taking approximately 185 centimetres of (Standard Red) and 85 centimetres of (Fluorescent Green) filament.  So that’s roughly 4 traffic cones per 10 metres – enough for a roadblock!

Specifications

(1) High precision dimension with 3+/-0.10mm range – creating a high quality finish

(2) Good roundness with 3+/-0.08mm range – creating a high quality finish

(3) Competitively priced

(4) Vivid colours

(5) Excellent customer service support