At a low temperature the colour on this 3D Printing Filament is Grey and as the temperature increases the filament turns White and when cools goes back to Grey, just holding it in your warm hand can change the colour tone.
The filament is delivered to you FREE OF CHARGE in a sealed, clear plastic bag, complete with a sachet of silica gel.
The Traffic Cone that you see was created using a MakerBot Replicator 2 X 3D Printer, taking approximately 185 centimetres of (Standard Red) and 85 centimetres of (Fluorescent Green) filament. So that’s roughly 4 traffic cones per 10 metres – enough for a roadblock!
(1) High precision dimension with 3+/-0.10mm range – creating a high quality finish
(2) Good roundness with 3+/-0.08mm range – creating a high quality finish
(3) Competitively priced
(4) Vivid colours
(5) Excellent customer service support